1. Place the clock where you want it to be in the workshop – see below if you would like to place your clock on the wall
2. Plug the female power cable that is already attached to the clock into the male power cable
3. Plug the power supply that is already attached to the male power cable into the mains
4. Plug the larger end of the scanner cable into the scanner and then plug the USB end of the scanner cable into the left side of the clock
5. Plug the clock into the network (using your own network cable)
Fixing the clock machine to the wall
1. Unclip the front face of the clock as pictured below:
2. Unscrew the four screws in the corners of the clock and pull apart gently until the clock opens
3. You will then see on the back of the inside of the clock, there are four screw holes which will allow you to attach the clocking system to a wall. Screws and raw plugs are included
Installation
When clicking on the Clock Monitor download link provided to you by email from Dragon2000, you will be asked to ‘Run’ the download. Once you have done this you will see the Dragon2000 Clock Monitor installer screen (pictured below) where you will need to enter your ‘Installation Key’ which will be attached to the same email.
If you no longer have the Clock Monitor Installer email, please contact our support team on 01327 222 333, who will be able to assist you with this.
As soon as you have entered the Installation Key press the ‘Install’ button.
Once installed, there will be a desktop icon named ‘Clock Monitor’ which the installer will have created.
When double clicking on the icon, the Clock Monitor will open and begin running in the background. Once connected to the network and power supply, you can now power on your clock.
You should see a message pop up at the bottom right hand side of your computer saying that the clock has been found. The clock is now set up and ready to go.
Find out how to assign clocking cards to employees